USB-C Power Interface

Tired of your communicator running out of power in the cold in the middle of your ride? You don’t have to worry anymore!

Works with Cardo, Sena, and other similar communicator units that use the USB Type-C port for charging only. Does not work with Chatterbox, Uclear, Syhpon Sound, some Cardo units, most older units or other brands that don’t stay on when being charged.

You will need to provide your own USB adapter if you have a Micro-USB type connector.

Requires DC voltage only. Cannot be used on snowmobiles that produce AC voltage, which will permanently damage the USB-C Power Module and your communicator. Read the disclaimer below before purchasing.

Designed with a contoured back and 3M adhesive, our USB-C Module can be mounted to any helmet.

Simply reroute your accessory power cord’s male RCA jack to our USB-C Module and now you can keep your communicator unit or action camera, heated shield, and Blizzard Buster powered as you ride. Our USB-C Module is designed for extreme cold and wet weather conditions.

It features a Type-C USB female port with a built-in O-ring to keep moisture out. Our short, flexible, male-to-male Type-C power cord also has O-rings on each connector, keeping moisture out of your communicator unit’s USB port.

Designed for snowmobilers by snowmobilers. No more communicator batteries dying in the cold weather.

If you have an older communicator unit with a Micro-USB charger, you can order a short USB-C to Micro-USB cord to replace the one in our kit. Try Amazon for something like this.

WARNING: DO NOT USE WITH AN OLDER SNOWMOBILE THAT DOES NOT PRODUCE DC VOLTAGE. YOU MUST VERIFY THAT YOUR SNOWMOBILE IS SENDING DIRECT CURRENT (DC) THROUGH YOUR HEATED SHIELD CORD TO THE USB-C POWER INTERFACE MODULE BEFORE PLUGGING IN. FAILURE TO DO SO WILL RESULT IN PERMANENT DAMAGE TO THE UNIT AND YOUR COMMUNICATOR OR ACTION CAMERA. If you are not sure if your snowmobile is producing DC voltage, you can verify with a multimeter. Or, if you’re currently using our Blizzard Buster and it is working, that means you are getting DC voltage.

BITEHARDER IS NOT RESPONSIBLE FOR DAMAGE TO YOUR DEVICES FOR NOT FOLLOWING THIS WARNING.

• Keeps your communicator unit powered during the ride so the cold doesn’t drain your battery

• Weather-sealed USB-C port + O-rings to help keep moisture out

• Plugs into your sled’s existing accessory/heated-shield power (RCA reroute)

• Powers more than communicators: action cameras, heated shields, Blizzard Buster, etc.

• Short, flexible cable = cleaner setup with less snagging

• Compatible with Cardo / Sena and similar USB-C “charge-only” units that stay on while charging

• DC voltage required (older AC-output sleds can damage the module/devices)

WARNING: DO NOT USE WITH AN OLDER SNOWMOBILE THAT DOES NOT PRODUCE DC VOLTAGE. YOU MUST VERIFY THAT YOUR SNOWMOBILE IS SENDING DIRECT CURRENT (DC) THROUGH YOUR HEATED SHIELD CORD TO THE USB-C POWER INTERFACE MODULE BEFORE PLUGGING IN. FAILURE TO DO SO WILL RESULT IN PERMANENT DAMAGE TO THE UNIT AND YOUR COMMUNICATOR OR ACTION CAMERA. If you are not sure if your snowmobile is producing DC voltage, you can verify with a multimeter. Or, if you’re currently using our Blizzard Buster and it is working, that means you are getting DC voltage.

BITEHARDER IS NOT RESPONSIBLE FOR DAMAGE TO YOUR DEVICES FOR NOT FOLLOWING THIS WARNING.